DLE-TEST15 : BATTERY
CHARGING test UNDER LOAD with the RAG v1.4 created on february 9, 2013 - JLN
Labs - last update march 15, 2013 All informations and
diagrams are published freely (freeware) and are intended for a private use and a non commercial
use.
Toutes les informations et
schémas sont publiés gratuitement ( freeware ) et sont
destinés à un usage personnel et non commercial I
am very gratefull to Thane C. Heins for his encouragements and
his very helpfull technical support Cliquez ici pour la version FRANCAISE
14 mars 2013
- DLE-TEST15
: Here is a
new test with the RAG v1.4 (Regenerative Acceleration Generator) with two
regenerative (Regen) coils. In this test, the 1st Regen coil is loaded
with two high power LED bulbs (SMD type) while, simultaneously,
the 2nd Regen coil recharge a lead battery. The RAG
v1.4 is a replication of the Thane C. Heins' ReGenX of
Potential Difference Inc. Canada.
Below
the setup of the TEST-DLE15 :
A Fluke 123 oscilloscope is used as a data logger for recording
the charging curve of the 12V lead battery (1.3Ah/20HR).
The
2nd Regen coil is placed so as to cancel the cogging
torque
produced by the magnetic attraction between the rotor magnets and
the cores of the Regen coils. This cogging torque generates a bad
magnetic drag effect which consumes power.
TESTS
RESULTS on the RAG v1.4 :
The REGENERATIVE
ACCELERATION EFFECT is stil present here in this setup. When
the 1st Regen coil is loaded with two LED bulbs and simultaneously
recharges the 12 V battery, the RPM speed increases and the
power drops at the input.
After
6'36" of working the voltage of the 12 V battery as gained
0.69 V
visits since december 29,2012