DLE-TEST09 : FULL TEST
UNDER LOAD of the Regenerative Acceleration Generator v1.3 created on february 9, 2013 - JLN
Labs - last update february 28, 2013 All informations and
diagrams are published freely (freeware) and are intended for a private use and a non commercial
use.
Toutes les informations et
schémas sont publiés gratuitement ( freeware ) et sont
destinés à un usage personnel et non commercial I
am very gratefull to Thane C. Heins for his encouragements and
his very helpfull technical support which have conducted me to
succeed in the replication of the ReGenX of Potential Difference
Inc.
February 28,
2013 - DLE-TEST09
: Here the
full tests and measurements conducted on the RAG
v1.3 (Regenerative Acceleration Generator) loaded with a High
Power LED bulb. With its High Voltage secundary coil, the RAG
v1.3 has already been successfully tested with a
lead battery in charge at its output. The RAG v1.3
is a replication of the Thane C. Heins' ReGenX of Potential
Difference Inc. Canada.
Here
is the setup used for the TEST-DLE09 :
In
this test, the light bulb used as the load (a High Power Led
bulb, Light House x21 Leds) is connected directly on the HV
secundary coil via a switch. The step down transformer is not
used here..
RESULTS
AND MEASUREMENTS ON THE RAG v1.3 :
I have
conducted a full serie of mesurements with and without the load
connected on the secundary coil along the full working RPM range
of the brushless motor. Below the full datas of the measurements
that I have conducted :
We can
observe that at low
RPM the RAG
works as a common motor/generator : when a load is connected on
its secundary, its turn speed drops and the input current
increases a
bit.
At a
certain speed,
when the secundary is loaded, the RPM of the motor INCREASES and the input
current DROPS.
Comments
:
These
full tests of the RAG (Regenerative Acceleration Generator) v1.3, a
replication of the ReGenX from PDI, fully confirm the
observations and the measurements conducted by Thane C. Heins.
visits since december 29,2012