How to use and test yourself the GEGENE...

How to use and test yourself the GEGENE...
created on december 28, 2012 - JLN Labs - last update december 30, 2012
All informations and diagrams are published freely (freeware) and are intended for a private use and a non commercial use.
Toutes les informations et schémas sont publiés gratuitement ( freeware ) et sont destinés à un usage personnel et non commercial

After having connected the load to the Tesla bifilar coil through some electrical plugs, put the coil on the middle of the induction cooker. Push the start/stop button and then the "function" button. By default, the delivered power on my induction cooker model is 2000 W, this is too much for this experiment : reduce the power to 1000 W with the (-) button.

At the beginning, the LCD shows the E0 error code (No cookware on the plate, cookware not fitted for induction) with a bip. To build up the EM coupling of the output coil, you need only to place temporarily a sheet of magnetic metal (180x180mm) or a magnetic cookware above the coil and in the middle of the induction cooker. When the output lamps are lit you must remove quickly the metal sheet because this metal sheet will heat up very fast. Never maintain the cookware or the metal sheet on the induction cooker in this experiment. If everything has been done correctly the halogen lamps will light at high power. You may move the output coil so as to get the maximum of light output. The flat bifilarTesla coil doesn't heat too much and you may move it without any problem with your hands.

Disclaimer : BE CAREFUL, USE EXTREME CAUTION !!!, this device uses High Voltage, ALWAYS switch off and disconnect the induction cooker before touching the induction plate or the output coil. Never touch the OUTPUT loads (lamps, heater, boiler) while the induction cooker is working. This experiment is not intended for the inexperienced. User of this document should be very carefull and experienced in High-Voltage electronics to try anything out ! If you do it the risk of any results is just yours. I take no responsibility of anything that might happen. This experiment is not intended for the inexperienced. User of this document should be very carefull to try anything out ! If you do it, the risk of any results is just yours. I take no responsibility of anything that might happen, let it be of a wrong information or anything else.

I have connected a wattmeter on the electrical plug of the induction cooker, it measures 1002 W at the INPUT, so it is fully in line with the programmed power of 1000 W :

Here, we are at the genesis of this project, I still have many tests and measurements required to validate these impressions overpower output.
For the moment the observations are very interesting and worth to be developed deeply... Be patient and Stay tuned...