The
System-G from Fran De Aquino
Engineering
the device...
Courtesy of Fran De Aquino and Steve Burns
created on March 17th, 2000 - JLN Labs - Last update April 14th, 2000
The System-G experiment has been performed successfuly by Fran De Aquino on January 27th, 2000 at the Physics Department of Maranhao State University in Brazil.
In the System-G torus, the ELF energy generated by the dipole antenna must be fully absorbed the atoms of the annealed iron lamina. The ELF energy is done by this equation below :
The curve below, shows that a System-G weight ( 35 Kg ) can be nullified at 60Hz with a current of 400 Ampere.
The use of the power grid for the basic System-G experiment has been conducted easily by using the power grid frequency ( 60 Hz, in Brazil ), this was energy consumming ( about 11 KW ). But for improving the efficiency of the whole apparatus, Power Input Vs weight lifted, its seems much adapted to use a lower frequency than previously for the ELF signal as shown on the table below :
You notice that,
to levitate a 100 Kg weight apparatus,
at 60 Hz we need 61 KW and for the same results, only 632 W is required at 1 Hz.
You may notice on the diagram above that only 1460 Watts are required to levitate 50 Kg at a frequency of 5 Hz...
The plot above,
shows the phase velocity reduced wavelength for an ELF antenna
in seawater (published by the US Navy in 1960's), in air and also
in a pure iron powder (for the System-G).
See also :
Engineering the System-G device by JL Naudin and Steve Burns
The System-G equations solver by J-L Naudin
The Gravitational Spacecraft from Fran De Aquino
Testing the System-G by JL Naudin
Email : JNaudin509@aol.com or mail to the JLN Lab's eGroup at : jlnlabs@egroups.com if you are a team member.
Return to the System-G home page